1945 Dodge Canadian

[GoranWC51]

Hi folks, I have been asked by a mate of mine who's looking for head gasket for a 1945 Dodge (C60?). I must shamefully admit that my Canadian Dodge knowledge is sorely lacking and I need all the help I can get.

What engines did the Canadian Dodge's have during the war? I know that the Dodge WC52 knock-off the APT had a 245 c.i. engine that differs from the regular 230 c.i. in several aspects.

http://www.mapleleafup.net/forums/at...1&d=1459710214

I am considering getting a Dodge like the one in the picture as the PPA (Popski's Private Army) had at least one which belonged to the motor pool of the unit.

http://www.mapleleafup.net/forums/at...1&d=1459710426

http://www.mapleleafup.net/forums/at...1&d=1459710426

Any and all help greatly appreciated. I'd appreciate if you could contact me via e-mail ( goran_noren@yahoo.com ) too, as I don't frequent this forum as much as I really should.

Kindest regards

[gordon]

236.6 cu in straight six flathead engines, 25" long at the head to block joint. They were known variously as 236 or 237 (because of the 0.6 cu in)

Your friends truck is a D60, T110L engineering code, but a D15 T222 code engine should have the same gasket. I'm not aware of any American gasket that will swop in directly, not even from a later American 25"long block - but it might.