#1
|
||||
|
||||
Unknown sheet metal part
I’m trying to ID this sheet metal part. It came with a Cab13 C15a that a friend recently picked up. We can’t figure out where it goes. It may not even be CMP.
It is 22” long, 2” high and 5-1/2” wide. Along the one edge there is staple holes. Any help would be much appreciated.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer |
#2
|
||||
|
||||
One last picture showing the sheet metal construction. .
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer |
#3
|
||||
|
||||
Interesting
It even has a bit of work in it to be in close proximity to a pipe of some sort.
Possibly goes near the exhaust or Radiator??
__________________
Pax Vobiscum.......may you eat three meals a day & have regular bowel movements. |
#4
|
|||
|
|||
Splash or Air Flow Shields
Hi Jordan
My hunch is that they are splash or Air Flow Shields, with two possible locations. Either side of the of the engine lower frame rails. Intent to reduce water mud from splashing up into the engine compartment. As lower shields the possition would also force the air flow from the fan to travel all the way to the rear of the engine. Noticing the little pairs of holes along the edge would indicate that there was either felt or canvas attached along that edge. Other possible location and purpose is as air flow shield up around the radiator to improve cooling. Now my basis for the first, if they are in deed Chevy CMP parts, is on the is that my HUP came with two left over bits stashed in the tool box, which after much searching the bolt holes looked like they fitted on the frame rails to close of the space. When I tried to put them back they were very hard to get into position, and would make service of anything behind and above very difficult. Given the condition of the shields I found they had been removed very early in the life of my HUP and only stayed with the HUP because of the large box to store stuff that might be needed. Will look for the shields I have to measure and photograph. Nice puzzle Jordan. Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com |
#5
|
||||
|
||||
Hi Jordan,
I got the same part with my C8A, and some other parts that I'm puzzled about. I see you got the same plate as I have. Do you know where that one is for? Cheers |
#6
|
|||
|
|||
Hi.
The part that you have in your hand must be mounted along the driver's side on the radiator support behind the steering gear. and then you can mount the splatsh plate on it. see MB-C2 (W) Supplement To Maintenance Manual MB-C2 Covering Special Cold Weather Equipment. cheers. Guy. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Modifying Princess Auto sheet metal brake | Jordan Baker | The Restoration Forum | 5 | 11-12-16 18:23 |
How to make exquisite sheet metal pieces | maple_leaf_eh | The Restoration Forum | 4 | 27-07-12 14:09 |
Calling sheet metal Guru Barry Churcher... | Bob Carriere | The Restoration Forum | 6 | 08-03-09 00:00 |
Pattern 12 Sheet Metal | Phil Waterman | The Restoration Forum | 1 | 27-02-05 00:04 |
Unknown part | Jordan Baker | The Carrier Forum | 2 | 10-01-05 05:05 |