19-Set Keyhole Grommets

[David Dunlop]

This is a spinoff from the thread I posted on the Grommet, Blind.

I had it in my head there was a PSU somewhere in my 19-Set equipment which had some of the blind grommets stuffed into some of the unused tie down key holes. I had wanted to photograph the unit as a reference in the other thread.

For those of you not that familiar with the 19-Set, two versions of the case for the PSU can be found, and within those two versions, a number of variations in style exist. The two basic versions are those cases built with only two sets of tie down key holes - one on either side of the case - and cases with a set of key holes on each of the four sides of the case. This latter style allows for mounting options for the PSU either sitting in it's normal vertical position, or stacked horizontally on top of the Transceiver Case. The obvious problem with the latter case is how to keep the weather out of the unused key holes.

Turns out, there is a key hole blind grommet in existence to do just what is needed. The attached photos are of my AC PSU for the Mk III 19-Set. They illustrate the four sided tie down key hole setup and also nicely illustrate the rubber key hole grommets. There are four of them in this case, blanking out the unused holes in the top and bottom of the case. As you can see, they have quite a flat profile.

The problem is, they are completely without a part number of any kind, so if anyone has some documentation regarding these grommets with part number references of any kind, please let us know.

Cheers,


David