VICKERS MK6B's resto

[Tony Smith]

Originally Posted by lynx42

An "EY' SMLE. .303 rifle fitted with the launcher cup, a grenade with base plate and a box of ballastites. The copper banding on the rifle is both to protect the hand holding the rifle and to give the holder a good non slip place to grip it.

Regards Rick.

Neither of those are the reason for the copper wire banding.

The Cup, Discharger is fitted to the nosecap of the No1 Mk3 Rifle, and is not supported by the barrel. On firing, the recoil of launching the grenade is transmitted through the Cup, to the Nosecap, and then to the timber stock. As Lynn has said, the wire prevents the timber from splitting from this recoil.

The No4 Mk1 Rifle was an improvement on this design, where the grenade launching spigot was fitted to the bayonet lug, which is part of the barrel. There is no need to wire wrap the No4 Rifle for grenade launching, as the stresses of firing are not transmitted through the timber stock, and there is no need to provide hand protection or grip.

It should also be noted that the No1 Mk3 SMLE has a thicker heavier barrel that the No4 Rifle, so if either barrel was liable to burst from excessive pressure, the No4 would go first.