|
|
#1
03-05-10, 21:22
|
||||
|
||||
M38A1 CDN3 windshield wiper motors
Does anyone have, or can anyone provide, a photo of the above showing the configuration of the tubing? (or a detailed explanation of how the routing goes).
I have replaced both motors and have suction to the left hand motor using the tube line to the lower tap. The right hand motor has tubing attached to the lower tap also, but it wanders back toward the left hand motor, terminating nowhere but it has a plastic "V" attached. I'm confused as to why there's two taps on each motor (input/output?) and how the plastic"V" fits into the arrangement of the whole. All 4 related shop manuals don't help me. Help!
__________________
PRONTO SENDS 
|
|
#2
04-05-10, 01:27
|
||||
|
||||
|
Hi Jon
I don't know if this will help not. Cheers, Barry http://www.willysmjeeps.com/v2/modul...ght=wiper+hose
__________________
Every twenty minute job is one broken bolt away from a three day ordeal.
|
|
#3
04-05-10, 17:13
|
||||
|
||||
|
Barry:
Thanks, but the images don't show enough detail. Blurry, too. Must have been a series of 10 beer photos 
__________________
PRONTO SENDS
|
|
#4
05-05-10, 05:30
|
|||
|
|||
|
I have an M38A1CDN2 and the tubing follows the same route as in the photo from B Churcher. Only one tap (on/off) on the lower left of the dash, plus on/off (push/pull) for each motor. Only one line, terminating at the RH motor, with a split off for the LH motor.
|
 |
|
|
Linear Mode
