#1
|
|||
|
|||
3 ton jack
Hello.
Can any one tell me what markings are on the 3 ton hydraulic jack please, and could any one provide pictures and measurements of the handle. Thanks Stephen |
#2
|
||||
|
||||
you mean this one?
it is a walker model 925,a model 927 is almost the same. second picture is the jackblockholder including the walker 927 i made |
#3
|
|||
|
|||
Hello Roy
Yes that is the one. Are ther any marks in the casting on the base please. Thanks Stephen |
#4
|
||||
|
||||
i have too look for it tommorow or monday.
but,what marks should have been on it? |
#5
|
|||
|
|||
Hello Roy
I picked up a jack a few weeks ago at a boot fair that looks like the right 3 ton jack but has a slightly different top. The only marks it has are hard to read but look like WH553 at one point and a 5 at another. There is a bit of green paint left as well. It is just over 10 and a half inches tall. I would be pleased to know what you think. If you think it is OK, Ross said that you recently made a base for yours, would it be posssable to give me some measurments for it please. Thank you very much, Stephen |
#6
|
||||
|
||||
Hi Stephen, Search this thread : 'mk1 canadian carrier jack block'
on this forum. kevin.
__________________
2pdr Tank Hunter Universal Carrier 1942 registered 11/11/2008. 3" Mortar Universal Carrier 1943 registered 06/06/2009. 1941 Standard Mk1 stowage Carrier, Caunter camo. 1941 Standard Mk1 stowage Carrier, light stone. 10 cwt wartime mortar trailer. 1943 Mk2 Daimler Dingo. 1943 Willys MB. 1936 Vickers MG carrier No1 Mk1 CMM 985. |
#7
|
|||
|
|||
Thanks Kevin
Will look for it now. Stephen |
#8
|
||||
|
||||
stephen, i get the measurements indeed from the carrier block post.
what is different on your jack top? as said i fitted a walker 927, it is almost the same than a 925,only difference is the location off the modelplate and the lifting plate on top is smaller. i have also a walker model 930,but from this one the baseplate is about a half inch wider. |
|
|