|
#1
|
|||
|
|||
Ford heating (cold weather equipment)
HELLO ALL
DOES ANYBODY KNOW MUCH ABOUT THE FORD HEATING STSTEM I HAVE THE FAN THAT BLEW THE HOT AIR AND I AM TOLD IT BLEW ACCROSS THE MANIFOLD IF SO A LEAKY MANIFOLD COULD BE SOMEWHAT OF A HAZARD I WOULD THINK I HAVE A MERCURY V8 ENGINE AND CANNOT SEE ANY TAKE OFF FOR WATER VIC UK |
#2
|
|||
|
|||
Arctic Kit...
Vic ..
Part of the Arctic kit was a heater that attached into the exhaust system exactly like a muffler(Silencer for y'all....) It had two (Inlet and outlet ports) for cab air that was ducteted to the windshield(Translation...windscreen) See Scan....... This device is a sealed heatexchanger and does NOT use exhaust fumes for heating direct... I tryed to scan an image but file size too big..I cut it down to 60% and was still too big ..I'll work on it later...Work time ...gotta go...
__________________
Alex Blair :remember :support :drunk: |
#3
|
|||
|
|||
ford cold weather equip
HELLO ALEX
Yes i can see what you are saying i got this fan unit from nordian services the ford people if ever there were, and wally at that time said it just had a shroud type cover that went over the right hand manifold thats looking at the vehicle from the front and thats where this fan i have fits to the cylinder block at times we used to come accross fords but were engaged on rebuilding chevs but still dismantled them and kept the parts and i have always wondered about this fan its a new one never been used and ive always wondered if it was realy a ford part i was assured it was but could imagine the exaust manifold leaking into the shroud and the fan blowing carbon monoxide into the cab i have quite a few parts of the ford winterised kit including the primer pump jets that fit below the carb and all the ducting parts but not the piping so although we are not doing a ford i still find it interesting as to how that system was fitted and worked without poisoning the driver vic uk |
#4
|
|||
|
|||
It would be easy to build once you see it..If I can get this sucker below 102 kilogiggles or what ever is holding up production..I wish there was some way to tell the size before we post.. I gotta be going to the wrong church...at least sittin' in the wrong pew.. Try this... If I keep at it I amaze myself...
There you go Vic.. The Arctic heating system.. heater4.jpg
__________________
Alex Blair :remember :support :drunk: |
#5
|
|||
|
|||
ford heating
HELLO ALEX
Yes thats the fan unit i have and the other parts are the same and i understand how the heat exchanger would work, but how is the heat exchanger fitted in relation to the manifold does it suround it or does it come off the exhaust at some other point thanks for the continued help alex vic uk. |
#6
|
|||
|
|||
HELLO AGAIN ALEX
Sorry alex i just read your last post and it tells me what ive just asked you as you say it goes from the exhaust at some point its the old eyes you know didnt have my glasses that day regards vic uk . |
#7
|
|||
|
|||
Hi boys!
On our late F15A will find a cap that closes a hole. What function does? 20210102_135556 - copia.jpg From another Ford 20200828_101034.jpg
__________________
Mariano Paz Buenos Aires, ARGENTINA 1944 Ariel W/NG 1945 FGT FAT |
#8
|
|||
|
|||
WhatsApp Image 2021-01-04 at 14.32.24.jpeg
Many thanks Mike Cecil for the reply... Quote:
WhatsApp Image 2021-01-04 at 14.32.09.jpeg
__________________
Mariano Paz Buenos Aires, ARGENTINA 1944 Ariel W/NG 1945 FGT FAT |
#9
|
|||
|
|||
Always happy to assist, except I think I made an error in saying "The diagram on page F1-12 seems to indicate the cabin outlet and driver's feet outlets are one and the same."
The diagram shows outlets aimed downward (with arrows) just before the windshield outlets, which I had not noted before. These seem to have a manual open/shut lever, and I suspect these are the vents aimed into the driver's and passenger's footwells. So the driver's feet outlet and the cabin outlet are not one and the same as I previously stated. Mike |
#10
|
||||
|
||||
Quote:
Interesting subject!
__________________
Regards, Hanno -------------------------- |
#11
|
|||
|
|||
Quote:
__________________
Mariano Paz Buenos Aires, ARGENTINA 1944 Ariel W/NG 1945 FGT FAT |
#12
|
||||
|
||||
Special Cold Weather Equipment
And thanks for your pics. Have now merged the two threads to build up our common body of knowledge.
The big question is: how much difference was there between the cold weather equipment for Ford and Chevrolet CMPs? See the thread SCWE (Special Cold Weather Equipment) Maintenance Manual Ref. text below: "some company variations existed"? winterized equipment.jpg
__________________
Regards, Hanno -------------------------- |
#13
|
|||
|
|||
One on a 39 Car
here is a heater on a 1939 ford car. Rare item
|
#14
|
||||
|
||||
Mb-f1w
Some photos of found on our MLU FB page. A Ford F60L 3-ton truck with SCWE parts. Note the battery box and the window vents.
327544998_590539756228804_7710821047564401823_n.jpg 329412881_1539619166549283_8302326283179025679_n.jpg More interesting is the data plate listing the usual manuals but with a "W" added, denoting this truck was Winterized. Rhett Fisher used to have a MB-F1W: "It was very interesting, though quite a palaver involving dumping a set amount of fuel into the sump (oil pan)". 333905497_195468616457033_7866800447151122057_n.jpg
__________________
Regards, Hanno -------------------------- |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
SCWE (Special Cold Weather Equipment) Maintenance Manual | martineaton | The Softskin Forum | 45 | 17-06-21 23:40 |
Heating units in LP2a Carriers | The Bedford Boys | The Carrier Forum | 3 | 10-05-20 17:03 |
Problem: loss of power when heating up - clues for the cause? | Hanno Spoelstra | The Softskin Forum | 25 | 09-04-16 20:35 |
Unissued Combat vehicle crew suit (cold weather) | SteveF | For Sale Or Wanted | 2 | 05-01-08 04:27 |
hot weather | Max Hedges | The Sergeants' Mess | 7 | 22-12-05 21:57 |