#1
|
|||
|
|||
C15A Instrumental Panel
Hi Fellows
I need information and pictures about late 5 instrument panel, light and ignition switch. Thanks in advance Luis Mariano Paz Buenos Aires , ARGENTINA. |
#2
|
||||
|
||||
Late?
Hi Luis - what do you mean by "late". I restore instrument panels and through searching on the forum you should find my work.
Bob
__________________
Chevrolet Blitz Half-Track Replica - Finished and Running Ford F15 - unrestored Ford F15A X 2 - unrestored Website owner - salesmanbob.com |
#3
|
||||
|
||||
My guess would be the individual round gauges.
__________________
1940 Cab 11 C8 Wireless with 1A2 box & 11 set 1940 Cab 11 C8 cab and chassis 1940 Cab 11 C15 with 2A1 & Motley mount & Lewis gun 1940 Cab 11 F15A w/ Chev rear ends 1941 Cab 12 F15A 1942-44 Cab 13 F15A x 5 1942 cab 13 F15A with 2B1 box 1943 cab 13 F15A with 2H1 box 1943 Cab 13 C8A HUP 1944 Cab 13 C15A with 2C1 box 1943 Cletrac M2 High Speed Tractor MkII Bren gun carrier chassis x 2 |
#4
|
|||
|
|||
Bob
Thanks for answering! Look in their post, some data required. It is right what say David, I mean the panel, composed of 5 round instruments.!!! Thanks David !!. |
#5
|
||||
|
||||
Later instrument panel
Here's a snap I took of the later, post-'44 "American-style" CMP instrument panel (F15A) for reference in restoring my C8A panel (it was completely gutted and cut out). This is a much easier panel to refurbish as gauges and speedos were GI-standard, same as used on Jeeps and other U.S. vehicles. Repro and NOS gauges are relatively easy to find - I just got a very nice NOS temp gauge, complete with threaded probe bulb and sender line and a repro amp meter via EBay. Speedos tend to be a little rarer, and be aware of variations in markings, etc. Hope this helps.
__________________
Member: Prairie Command, Ex-Military Land Rover Association 2110, MVPA 29055 ’45 Chevrolet C8A CMP HUP “Staff Car ”, ’82 Land Rover Series III, 109" ex-MoD, ’80 Honda CX500D, ’48 Ferguson TE20 |
#6
|
||||
|
||||
Switches
And here is a shot of the switch plates as I found them on my truck, which shows you what's what and where. Note the dimmer switch mounted on the left side of the housing.
__________________
Member: Prairie Command, Ex-Military Land Rover Association 2110, MVPA 29055 ’45 Chevrolet C8A CMP HUP “Staff Car ”, ’82 Land Rover Series III, 109" ex-MoD, ’80 Honda CX500D, ’48 Ferguson TE20 |
#7
|
|||
|
|||
Red light in the stop switch isolation switch location
Quote:
Noticed that someone has installed a warning light in what would be the location for the stop switch isolation switch, do you know what it is connected too? Turn signal, high beam indicator, hazard indicator or something else? Just in passing I rewired the stop light isolation switch so that it provides power to the brake lights which passes through a signal flasher in parallel with the brake pressure switch. With the isolation switch in the on position it causes the rear brake lights to flash. When you step on the brakes the lights go on and do not flash. I also did install a indicator light for the high beam and one for the brake flashers. About the gauges over the years I have been able to collect spare gauges including the temperature some of them have slightly different markings than the original CMP gauges which I suspect did not all match depending on the supplier. One comment about the temperature gauge and sender tube assembly most of these that I have found have sender tubes that are significantly shorter than the original Chevy CMP. Some of them are long enough though if you route the tube carefully. Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com |
#8
|
||||
|
||||
Wiring and switches
Hi Phil - I don't recall if that light wasn't even connected, the wiring behind the panel was so messed up and cut to bits - which is why I needed a whole new harness and loom from you. I'm just hoping to get things as close to original as I can, plus turn signals.
The sender tube on the temp gauge I got is 42", which I thought ought to be long enough, but the seller had longer ones at 81" which I figured would be far too long.
__________________
Member: Prairie Command, Ex-Military Land Rover Association 2110, MVPA 29055 ’45 Chevrolet C8A CMP HUP “Staff Car ”, ’82 Land Rover Series III, 109" ex-MoD, ’80 Honda CX500D, ’48 Ferguson TE20 |
#9
|
|||
|
|||
'Original'
Here's a dash panel waiting to be re-installed in my 1944 Chev HUW. To the best of my knowledge, it's as authentic as I've been able to determine after a 'few' years' of research.
|
#10
|
|||
|
|||
work bench
Bruce....I see you cleaned up your work bench...
|
#11
|
||||
|
||||
Very nice looking panel and pic, and it also reminds me of where the dash jewel should go.
__________________
Member: Prairie Command, Ex-Military Land Rover Association 2110, MVPA 29055 ’45 Chevrolet C8A CMP HUP “Staff Car ”, ’82 Land Rover Series III, 109" ex-MoD, ’80 Honda CX500D, ’48 Ferguson TE20 |
#12
|
||||
|
||||
F60L Gauges
Quote:
Since this thread is about gauge clusters - could someone identify the missing gauge out of the cluster from a Cab 13 F60L. Kind Regards Lionel
__________________
1940 Chevrolet MCP with Holden Built Cab (30 CWT). 1935 REO Speed Wagon. 1963 Series 2A Army Ambulance ARN 112-211 Series III ex-Military Land Rovers x 2 |
#13
|
|||
|
|||
Temperture
Simple Temperature, now next questions did Fords use the same as Chev.
Here is the instrument group from my `45 HUP. Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com Last edited by Phil Waterman; 31-01-10 at 01:48. Reason: wronge answer |
#14
|
||||
|
||||
G'day Phil
Quote:
Thanks for the identification Phil. Do you have a photo of the temperature gauge that you could post? Thank you. Kind Regards Lionel
__________________
1940 Chevrolet MCP with Holden Built Cab (30 CWT). 1935 REO Speed Wagon. 1963 Series 2A Army Ambulance ARN 112-211 Series III ex-Military Land Rovers x 2 |
#15
|
|||
|
|||
Now that is known as real time
Hi Lionel
Your response to my posting was going up at the same time that I was correcting my first incorrect post and adding a picture. Not bad for opposite side of the world. Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com |
#16
|
||||
|
||||
G'day Phil
Quote:
Regards Lionel
__________________
1940 Chevrolet MCP with Holden Built Cab (30 CWT). 1935 REO Speed Wagon. 1963 Series 2A Army Ambulance ARN 112-211 Series III ex-Military Land Rovers x 2 |
#17
|
|||
|
|||
Current time 7:56 PM
Time now is 7:56 PM eastern standard time here in the States
Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com |
#18
|
||||
|
||||
Temp Gauge
Quote:
Did Ford temperature gauges vary much in size and style throughout the war in the years that the Cab series 13 were made and the different countries of assembly? Kind Regards Lionel
__________________
1940 Chevrolet MCP with Holden Built Cab (30 CWT). 1935 REO Speed Wagon. 1963 Series 2A Army Ambulance ARN 112-211 Series III ex-Military Land Rovers x 2 |
#19
|
||||
|
||||
Saturday evening. You lot Downunder (in the eastern bit anyway) are ahead of us, by 16 hours at this time of year.
__________________
SUNRAY SENDS AND ENDS :remember :support |
#20
|
||||
|
||||
Quote:
__________________
You can help Keep Mapleleafup Up! See Here how you can help, and why you should! |
#22
|
||||
|
||||
Quote:
Note too, the Ford dash lighting is in a fatter, squat housing placed lower on the panel than the long slim housings used on Chev's ("Cigar Tube" same as Jeep/GMC)
__________________
You can help Keep Mapleleafup Up! See Here how you can help, and why you should! Last edited by Tony Smith; 31-01-10 at 06:46. |
#23
|
||||
|
||||
Tony,
Don´t count on it. It comes from the ex-Norwegian Army stock of M7 Snowtractor parts which Sean recovered years ago. That is why it is painted white. Hanno
__________________
Regards, Hanno -------------------------- |
#24
|
||||
|
||||
So there are no variations in the faces or temp scale, just a straight needle or arrowhead needle? Anyone else seen any other variations?
__________________
You can help Keep Mapleleafup Up! See Here how you can help, and why you should! |
#25
|
||||
|
||||
The screw that is between the choke and the dash emblem. What is it for on the back side of the panel?
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer |
#26
|
|||
|
|||
A condenser. I just need to remember what it attached to.
|
#27
|
|||
|
|||
Likely connected to the ignition or charging systems.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... |
|
|