|
#1
|
||||
|
||||
Amplifier Rack
Can Anyone help me with angle iron size on this radio rack?
It looks to be 1 1/2 or 1 1/4 X3/16. Photo from Google Thanks, Barry |
#2
|
|||
|
|||
The angle is 1.5" by 1/8". The corner gussets are 1/8" plate and the four corner front/back angles are bent 1/8" plate as well (they are not symetical...one side is longer than the other and the tops and bottoms are different). Additionally there are two channel stiffeners on the top between the front and back angles.
If you want I can sketch up dimensions and construction details for you. |
#3
|
||||
|
||||
That would be awesome Bruce. Thank you very much.
Barry |
#4
|
|||
|
|||
Hello Barry and Bruce also.
I'm in Ottawa if you want see the actual frame. LMK. Geoff |
#5
|
|||
|
|||
Let me know if this make sense. I can take some pics that might clarify things and show where the welds are, etc.
|
#6
|
||||
|
||||
Thanks for the incredibly detailed drawings Bruce. I sure appreciate the effort you must have gone to.
Cheers, Barry |
#7
|
|||
|
|||
I can't believe I found my sketch. for parts E and F The lower notation is "Screwed to underside of front & back angles" This is shown on the bottom sketch. The upper notation is " 1" by 1/2" channel 1/8" thick " and those dimensions are O.D.
The top angles are welded on to the rails in four places each, the welds on the underside of the channels where they contact the 3" channels they sit on. The welds are the full width of the 1-1/2" angle on the front, middle, middle and rear surfaces. There are no welds on the ends or top. Make sense? The finish is matt brown wrinkle paint, probably not available. What I have done is used black which should be available then spray the brown over top. That is if you can even get wrinkle paint anymore. Extra springs nothing. The amplified set goes in the HUW on a flimsy table screwed to the floor. The weight and being top heavy must have been a problem. |
#8
|
||||
|
||||
Thanks Bruce, that's a great help.
Barry |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wanted: Ws19 set rack | Jesse Browning | For Sale Or Wanted | 4 | 30-12-15 13:53 |
Wanted: Pioneer rack | Jack Innes | For Sale Or Wanted | 2 | 29-10-14 17:22 |
2 gallon can rack | stephen crowhurst | The Carrier Forum | 2 | 25-04-13 15:37 |
Rack | peter simundson | For Sale Or Wanted | 1 | 07-01-12 03:41 |
WS 19 Set Amplifier Vibrator Power Unit for sale | Dean (Ajax) | For Sale Or Wanted | 0 | 27-11-11 23:44 |