|
|
#1
11-01-09, 15:39
|
||||
|
||||
Help needed for part i.d. again.............
Hi everyone, is this the type of Horn that would have been fitted to the Canadian Mk1 carrier
__________________
2pdr Tank Hunter Universal Carrier 1942 registered 11/11/2008. 3" Mortar Universal Carrier 1943 registered 06/06/2009. 1941 Standard Mk1 stowage Carrier, Caunter camo. 1941 Standard Mk1 stowage Carrier, light stone. 10 cwt wartime mortar trailer. 1943 Mk2 Daimler Dingo. 1943 Willys MB. 1936 Vickers MG carrier No1 Mk1 CMM 985. 
|
|
#2
11-01-09, 15:57
|
||||
|
||||
|
Hi Kevin
That looks close to what I used. Mine seemed to have a less pointy back cover to it. I also had to heat up and straigten the mount. When you do just remove the two little washers between the spring steel parts. If you don't they will go flying off. I would say if that one works and the price is good then get it. You can always replace the back latter on. I got mine off of EBay by looking for "vintage/old Ford horns". I think I found it within 2 weeks and got it for about $15.oo CAD
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer
|
|
#3
11-01-09, 17:31
|
|||
|
|||
|
Carrier forum Help needed
Jordon .That is the Ford horn that is used on the CMP and even cars .Should be ok for the carrier . George
__________________
George is hooked on OD 5 window DT969 8 ton Fruehauf trailer M2A1Halftrack ,CMP #11 F15A1 #13 F15A1 RAF Fordson Tractor, 42 WLC HD No.2MK11 CT267514 center CB24713 bottom hull25701 ,No.2 MK2 parts MK1 10128 ,(2) MK1 ,Parts Hull9305 .Hull 10407 Hull plate # 7250 all have walk plate on back steps 1917 Patent modle amphibious army tank
|
 |
|
|
Linear Mode
