#1
|
|||
|
|||
CMP Lamp internals
Hi guys.
I need to replace the wiring on some of my lamps. Any source for or tip for what to use for replacing the crimp on bulb connector at the end?? Svenn |
#2
|
|||
|
|||
Try Rhode Island Wiring Service
Hi Svenn
Take a look at http://www.riwire.com/ check supplies and then look at Washers, Buttons,and Screws. Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com |
#3
|
|||
|
|||
Bare about 1/16 of an inch of wire on the end of your new wire, insert through a suitable size small flatwashr, bend outwards the strands, and solder them to the flatwasher. If you were to pre-tin the washer, it would solder together easily, but should work either way. Of course, use rosin core solder, and not acid core.
For new fiber washers and springs, you can salvage them out of more modern lamp sockets. |
|
|