|
|
#1
23-12-11, 06:00
|
||||
|
||||
camel back drill
This antique drill press I spotted in an old local garage . After investigation I discovered that these are generically known as ' camel back ' drills . Made by many firms from the 1880's until the 1960's . This particular one is a McPherson, made in Melbourne in the 1930's to 40's , it has power feed to the down feed . These drills were still listed in the 1966 McPherson catalogue .
Why did they last so long in production ? Amazing torque and strength . Slow turning , they will happily drill 30mm holes in just about anything . When modern safety and health rules , these are not allowed in factories today . They require constant oiling ..another time factor thing..hence many were junked .
__________________
1940 cab 11 C8 1940 Morris-Commercial PU 1941 Morris-Commercial CS8 1940 Chev. 15cwt GS Van ( Aust.) 1942-45 Jeep salad 
|
|
#2
23-12-11, 06:09
|
||||
|
||||
|
pics
The 4 speed power drive is taken from the main horizontal shaft .
__________________
1940 cab 11 C8 1940 Morris-Commercial PU 1941 Morris-Commercial CS8 1940 Chev. 15cwt GS Van ( Aust.) 1942-45 Jeep salad
|
|
#3
23-12-11, 07:25
|
||||
|
||||
|
cattle dog
This is the link to the 1966 McPherson catalogue . McPhersons also manufactured lathes and they sold as the MACSON brand . The main factory was in Kensington , near Nth. Melbourne . Their foundry was at Tottenham apparently .
http://www.titaniumstudios.com/toolj...6-Drilling.pdf
__________________
1940 cab 11 C8 1940 Morris-Commercial PU 1941 Morris-Commercial CS8 1940 Chev. 15cwt GS Van ( Aust.) 1942-45 Jeep salad
|
 |
|
|
Linear Mode
