|
|
#1
27-02-09, 10:53
|
||||
|
||||
Gasket patterns
Just wondering whether anyone has taken the time to scan or draw (CAD) accurate patterns for cutting gaskets for the various parts on a CMP.
If so this is the place to share what you have done, although you'll need to host the images in full-size somewhere like Photobucket.
__________________
Film maker 42 FGT No8 (Aust) remains 42 FGT No9 (Aust) 42 F15 Keith Webb Macleod, Victoria Australia Also Canadian Military Pattern Vehicles group on Facebook https://www.facebook.com/groups/canadianmilitarypattern 
|
|
#2
27-02-09, 15:20
|
|||
|
|||
|
Yes
Hi Keith
Yes I have scanned gaskets and then printed the outlines on gasket stock. There are a lot of tricks to it that when I have a moment I will post. Biggest issue is that if you scan an old gasket or part do it at the highest resolution you can you will find there is less distortion. Also a lot of tricks to getting printer to actually print to size. Below is a sample but because of the image restrictions you can see the detail.
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
