#1
|
|||
|
|||
Help - ID Ford 15a part
I can't remember where these brackets came from when I took them off an original Cab13, I remember them from around the radiator but can't figure out where they actually go.
Can someone post a picture of here they go. Thx Jim |
#2
|
|||
|
|||
Radiator brakets
Hi Jim,
That's got quite a few of us stumped based on the number of views and lack of replies. I haven't seen that on my Australian assembled F-15A anywhere however that doesn't mean it was never fitted, or maybe only fitted to Canadian built vehicles. Annoying little bits often get removed and thrown behind the chicken coop over the years. Restoration is often about finding those annoying little bits again (passenger seat floor grab handle for example) The 1943 15 CWT 4 x 4 Parts List doesn't show anything in the radiator diagram nor does it appear in the list. Again it could have been a later fitment deemed necessary from in-field experience. It seems well made and finished so it seems to be something more than bush engineering. That said, however, my only guess is if you lack the shroud from the grill to the radiator this is a bracket to support the top of the radiator used in its place. Without the shroud, there is nothing to support the radiator from forward movement. There is a hole in the radiator upper to lower tank side supports to which this could be attached. If you have the shroud then this throws my theory completely out! Hope someone else can shed some light on it as it has got me curious too. All the best,
__________________
F15-A 1942 Battery Staff Jacques Reed |
#3
|
||||
|
||||
Brackets
I've not seen them either on any Australian or the fully imported F15 cab 13s either, but I wonder whether they may be something to do with supporting the de-misting setup on some later Canadian built Ford cabs.
__________________
Film maker 42 FGT No8 (Aust) remains 42 FGT No9 (Aust) 42 F15 Keith Webb Macleod, Victoria Australia Also Canadian Military Pattern Vehicles group on Facebook https://www.facebook.com/groups/canadianmilitarypattern |
#4
|
|||
|
|||
Jim. Is it perhaps just my eyes, or are those bolts spring loaded as if to keep something in a 'home position' but also permitting some limited movement?
David |
#5
|
|||
|
|||
I have the shroud so that's not it.
Here is a tube video of the motor running, it has a 1943 Ford rebuild tag on it. https://m.youtube.com/watch?v=MQymWPg1nG0 Jim |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ford Inlet Manifold part No. prefix C29SR question | Lynn Eades | The Softskin Forum | 7 | 01-07-15 19:37 |
Info needed: Please ID part# Ford BB7118 | Hanno Spoelstra | The Restoration Forum | 2 | 05-10-13 21:24 |
For Sale: Ford CMP part | peter simundson | For Sale Or Wanted | 2 | 08-08-12 03:58 |
Ford Radiator Part Number Query | Lynn Eades | The Carrier Forum | 4 | 23-01-10 23:22 |
Ford and Chevy part is the same size? | NORTH-SHORE(CANADA) | The Softskin Forum | 4 | 22-12-08 01:40 |