Wanted: M151A2 CDN Door Hinges / Frames

[Sean McKee]

I am looking for CF-pattern Right and left side top door hinge sockets for my M151A2 CDN. These are the upper hinges that attach to the outside of the window frame.

Also, if anyone has a right and left side set of the rigid door frames (I have the covers) I am a willing buyer.

For both, if you have, but are unwilling to sell, I would welcome a diagram/photos/measurements.

Thanks, all! 😎

Sean

[rob love]

They were a modification related to the roll cage installation. They were made locally. I was trying to get a pair for another member here, and they were not made consistently. If I remember tonight I can take a picture of the mod and post it on this thread.

[maple_leaf_eh]

Originally Posted by Sean McKee

I am looking for CF-pattern Right and left side top door hinge sockets for my M151A2 CDN. These are the upper hinges that attach to the outside of the window frame.

Also, if anyone has a right and left side set of the rigid door frames (I have the covers) I am a willing buyer.

For both, if you have, but are unwilling to sell, I would welcome a diagram/photos/measurements.

Thanks, all! ��

Sean

As Rob mentions, the roll cage changed the factory parts. I did not know the pieces were then locally made.

There is a bracket for a hook on the vinyl door which is in line with a hole on the door sill. Is that your question?

Or are you asking about the rod over the door and its 90-deg attachment?

[Eric B]

Hello Sean

This would be what you are looking for. You will most likely have to make one yourself.

You can use either style of rods.

I do not want to take you away from this page...but there is a Canadian M151a2 specific FB group, which has this and other CDN mods posted in it.

The drawing originated from Rob Love.

Thanks
Eric

[rob love]

Thanks for posting that Eric.
I can tell you that the brackets I saw were nothing like that shown in the photo. They were quite crude, and held on with regular 1/4 bolts as opposed to the pretty machine screws shown. And no two seemed to be alike.

[Sean McKee]

Originally Posted by rob love

Thanks for posting that Eric.
I can tell you that the brackets I saw were nothing like that shown in the photo. They were quite crude, and held on with regular 1/4 bolts as opposed to the pretty machine screws shown. And no two seemed to be alike.

Thanks, everyone! That is the bracket I was looking for. Eric B thanks for the drawing😁