#1
|
||||
|
||||
Part ID needed.
Could I get some assistance identifying this part please?
Stamped markings are GMH-W S (ie Australian made at General Motors Holdens at Woodville in SA), and A78681T-5, and 18683T, and ADD-A-5-279. Soft padding under the canvas, and is shaped offset, such it might be "handed" (ie LH or RH), and possibly only half of a pair.
__________________
You can help Keep Mapleleafup Up! See Here how you can help, and why you should! Last edited by Tony Smith; 02-06-19 at 23:26. |
#2
|
||||
|
||||
I.d.
I think it could be the shoulder pad for a 20mm Polsten. Woodville made a lot of parts for that setup.
|
#3
|
|||
|
|||
Shoulder rest for a 6 pounder anti-tank gun ,also used in Armoured cars.
Rob...………..rnixartillery |
#4
|
||||
|
||||
It certainly looks like some sort of shoulder pad, but the Holden-made Polsten pics on the Holden Retiree's Club page show the Holden guns had canvas webbing for the shoulder support.
__________________
You can help Keep Mapleleafup Up! See Here how you can help, and why you should! |
#5
|
||||
|
||||
PM sent Tony
|
#6
|
|||
|
|||
6-pdr
I agree with RIX: 6-pdr gunner's shoulder rest/mount.
Mike |
#7
|
||||
|
||||
Looks close
6 pdr gunners rest.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wanted: 19 set part needed | peter simundson | For Sale Or Wanted | 2 | 10-11-18 01:21 |
Help needed for part i.d. again............. | kevin powles | The Carrier Forum | 2 | 11-01-09 17:31 |
M2 BMG part needed... | paul53 | For Sale Or Wanted | 0 | 07-02-07 04:40 |
Hub part needed & wiring | Bryan | The Carrier Forum | 15 | 20-10-05 08:43 |
Speedometer Part ID Needed | Bob Moseley (RIP) | The Restoration Forum | 8 | 28-02-05 10:04 |