#1
|
|||
|
|||
19 set part needed
Got the part THANKS
Aerial Feeder assembly PC 76486C which goes in a Canadian Lynx Armoured Car below the Mounting Aerial Base No. 3 Mk. 1. The top of this plate has a post and small screw that holds the aerial pigtail and on the underside is a fitting that holds the co-ax cable from the Variometer. Thanks Peter Simundson Last edited by peter simundson; 13-11-18 at 21:52. Reason: Got the paqrt |
#2
|
|||
|
|||
I have a PC76488 (ZA 2992) that has the pigtail post on the top and co-ax connector on the bottom. Close enough?
|
#3
|
|||
|
|||
Thanks Bruce.
Can we try it when you come over?
Peter |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Part number info needed | Keith Webb | The Sergeants' Mess | 2 | 09-07-10 21:04 |
Help needed for part i.d. again............. | kevin powles | The Carrier Forum | 2 | 11-01-09 17:31 |
M2 BMG part needed... | paul53 | For Sale Or Wanted | 0 | 07-02-07 04:40 |
Hub part needed & wiring | Bryan | The Carrier Forum | 15 | 20-10-05 08:43 |
Speedometer Part ID Needed | Bob Moseley (RIP) | The Restoration Forum | 8 | 28-02-05 10:04 |