|
|
#1
18-05-18, 20:36
|
|||
|
|||
Starting the CMP
Hey
So we got our CMP running for the season and it was starting fine. I drove it for about a half hour and then it stalled. When I went to start it, the engine was cranking over very slow and wouldn't start. Had it towed and when it came off the flatbed, I tried and it started fine. It stalled a few minutes later and again when I started it, it cranked over very slowly. The battery was tested and volts are fine (6 volt battery) and load tested and it was fine. The starter was tested to see if it works and ran fine. the wiring to the starter is 4 gauge. There is also a kill switch for the battery. Any ideas what might be causing the problem? Thank Joel 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Starting Up My 19-Set Mk III Cdn | David Dunlop | The Wireless Forum | 9 | 13-11-17 06:02 |
| For Sale: Mk2 Carrier starting handle | kevin powles | For Sale Or Wanted | 1 | 06-10-17 08:17 |
| Trouble starting ’40-42 16H Norton M/C | Chris Preston | The Restoration Forum | 4 | 01-08-17 19:48 |
| Crank Starting | Harry Moon | The Softskin Forum | 6 | 23-07-13 22:16 |
| Hot engine starting | Barry Read | The Carrier Forum | 17 | 13-05-06 18:25 |
Threaded Mode