#1
|
|||
|
|||
Staghound hull MG casement?
Been putting together some markings for Bronco's 1/35 scale Staghound, and I end up running out of room on the glacis plate, such that the arrangement does not quite match that of a period photo:
28th June 1945.jpg staghound front markings 2.jpg I've taken a measurement of the width of the kit part (cast mound including the weld bead), and then placed that over a scan of the glacis plate. Placing that unit of measure three times across the glacis, it ends up extending past the kit part. T17E1_pic2 measure.jpg Using the same method on an actual photo, the result is different. So wondering if maybe the kit part is tad large. Anyone have access to official blueprints, or actual vehicle and provide a measurement of the width for the MG cast mound? The height measurement against the glacis plate would be good to have too if possible. regards, Jack |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Hull welding | Manfred Müllner | The Carrier Forum | 5 | 10-06-13 23:26 |
At last here are some photos NZ LP hull | Lew Skelton | The Carrier Forum | 12 | 29-04-11 10:22 |
Hull # | gary_bath_jr | The Carrier Forum | 5 | 12-07-10 20:31 |
Wanted, Interior hull Dome lights for Staghound | T17E1 | The Armour Forum | 9 | 15-03-09 21:57 |
UC Hull | Richard Coutts-Smith | The Carrier Forum | 14 | 08-04-08 01:25 |