|
|
#1
14-05-18, 11:51
|
|||
|
|||
FAT seat holders and seat parts replicas
Hi folks.
Due to lack of 2 seats and 1 seat holder in my FGT I am gonna make exact replicas of blocks holding FAT seats on the floor (both steel plate and wooden block) and the parts to convert a normal CMP seat to FAT one (4 nipples and the securing lever.) Would anyone be interested in those parts? I think they are not gonna be expensive. If yes please write it to the comment. I am gonna make the sheet metal ones with a plasma cutter, so I can share the digital plan to cut it - cheaper than to send steel by post  Regards, Frankie Last edited by Frantisek Nachlinger; 16-07-18 at 23:58. 
|
|
#2
16-07-18, 23:50
|
|||
|
|||
|
Just started production of the parts needed to make a FAT seat from a normal CMP seat.
The seat holders will be available too. Exact replicas of my originals. If anyone interested, let me know The "nipples" for the seats will be ready in few days, the securing lever in few weeks.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Seat | kevin powles | The Carrier Forum | 8 | 22-02-18 05:36 |
| For Sale: CMP seat base seat covers, NOS | kevin powles | For Sale Or Wanted | 9 | 21-06-16 00:58 |
| I am looking for parts for a '42 WLC Tandem Seat. | DeltaMike | For Sale Or Wanted | 0 | 12-04-11 22:26 |
| FS: Original 1943 Harley-Davidson WLC Tandem Seat Assy Parts | Prem | For Sale Or Wanted | 4 | 17-01-10 06:23 |
| What does this seat fit? | Bob McNeill | The Softskin Forum | 2 | 21-04-09 11:08 |
Linear Mode
