|
|
#1
09-10-12, 19:21
|
|||
|
|||
Interesting Solution to Chev Oil Leak
Hi All
I was looking through some of the back pages of the JIM CARTERS Web site http://www.oldchevytrucks.com/ and happened to click on the Articles Tab http://www.oldchevytrucks.com/blog/ which has as one of its sub choices Technical Articles http://www.oldchevytrucks.com/Technical-Articles.asp . Any way there is a lot of interesting stuff for us Chevy nuts, including this rather interesting approach to solving the problem of valve cover leaks caused by warped covers. http://www.oldchevytrucks.com/blog/i...216-oil-leaks/ Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com 
|
|
#2
10-10-12, 04:04
|
|||
|
|||
|
Fantastic.....
Wonder if we can make one out of wax....... and cast some of them devices..
Making the the 3/4 steel band with a jig should be simple enough.... Sounds like a Winter project....... can prototype using lead then move to brass or aluminum ( old tranny cases and pistons) Bob
__________________
Bob Carriere....B.T.B C15a Cab 11 Hammond, Ontario Canada
|
|
#3
10-10-12, 05:21
|
|||
|
|||
|
Just chain an oil drain pan onto the frame under the engine, with an electric pump at the low end running the leaking oil back up to filler hole on the 216 chev engine.
Ford Flathead all the way!!! 
|
 |
|
|
Linear Mode
