power pump.

the power pump is a Canadian Fairbanks-morse # 700 typhoon duplex , leather packed piston pump like the one in the movie.

my unfortunate original shortened pto shaft, he is about 10 "too short

some drawings from a manual Dodge T-222
200 GAL waterbowser

normally he will sell the manual to me, there is a wealth of information.

Thanks for that Guy. :note:
I just found that manual reprint courtesy of Rob van Meel's webshop; the order is placed!

Owen.

Hi owen
it is a very good manual with a lot of information, if he does not sell it I will also get it from Rob.
unfortunately there are no sizes mentioned or large of filters or the like.
greetings Guy

I am very happy today at the further combing of the old garage I found the second runnigboard,
she also served as a shelf under an old workbench,
I also found an old I think Canadian work box with 11 nos English bicycle lamps in their original condition still in the box.
I will post some photos on the forum later

here are some pictures of the runnigboards I spoke of which I still found in the garage.

I hope I will find original parts, hopefully a filter or a pump

owen

the power pump is driven directly by the pto by means of a cardan shaft.

the pto is switched on by a handle inside the cab.


greetings Guy.

here some pictures of the lever in the cabin. note the tag that is mounted on the handle.

also note that the handle was painted in red

The salvaged bits are for my MWC, I will post a couple of photos to show what they look like now in a couple of days.

According to the Bedford/Morris Parts list the Mono Pump is a type SC3

On earlier MWC's the pump was attached to the from bumper and driven directly off the engine. Later variants use a power take off.

(I am also looking for pumps and filters, especially a mono pump)

Cheers
Richard

Thanks for posting those photos Guy. :thup2: My Chev is a 4x2, so no transfer case. The pump was driven off a PTO mounted to the side of the transmission. Similar to Richard's MWC setup.

Owen.

Excellent work Guy I'm following this thread with interest also thank you for posting some very useful photos :thup:

Pete

Hey guys.

indeed the p.t.o. departs from the transmission.
see the first 2 images.

on the last 2 images you can see that mistakes are made in the factory too, if you look closely you can see on the floorboard the adjustment where the cut-out for the p.t.o. was first made and later put something aside and the old holes and slip are backed up.

thanks again for your response here and I wish everyone a happy new year.

Hey,
Top of water filter further finished.

the result here.

Greetings Guy.

Hi guys
here an update of the works on the water bowser.
we passed the car inspection and everything was fine.
here also some pictures of the further construction.
cheers.

Guy,

Congrats! Very nice work. Are you planning to take the truck to any events in the near future? (Wings and Wheels?, XXX Corps?)

regards,
Alex

hi Alex

the intention is to ride it in the liberation run through a part of Belgium. if I have my license plate on time

cheers. Guy.

Hi everyone .

we drove a test drive today and got a very loud knocking sound, when I release the trottle it stops immediately so it must be a vacuum problem someone has an idea what the problem is.

could the problem come from the Vacuum control on the distributor ???

Guy.