[jaap de wit]

now the engine is in place the generator and starter have to be installed.
the generator i took apart for cleaning and replaced the bearings, reconnect the wireing it was in big nead of this. for the starter I did the same.
the fuel pump, I cleaned to and gave it a new membrain, gasket and installed it in it's place. the waterpump was next it was in nead of a new bearing and gasket I used a press to install the new bearing and put the pump together and placed it on the engineblock I used liquit gasket so it (I hope) will not leak. the intake and exhaust manifolds were bolted on useing new gaskets and rings in the intake ports. there is a new thermo spring on the thermovalve in the exhaust (hot spot).
it starts to look like a engine again, but will it start ???
cheers jaap