Email adress matey. If you email Rick he may give you the front DXF's alternate i will get another card tube and start plotting......takes me ages to draft them out though..i need to do a set for one of the lads here to CAD up. Mind folks looking at Ricks prices if you are on the same peice of rock / country as him that is a pretty good price
also Rick i would not cut the lower edge holes... most folk still have these frame rails on their carriers, cut the others but not the bottom edge...its better to offer the plate up and drill them, that way any discrepancies between machines wont throw the holes out of kilter......so to speak.
great work though buddy well done