[Jordan Baker]

Here are the pictures. I didn't get a chance to measure it but the distance they are out is about the same as the thickness of the flange. Im going to try some bolts that are a bit longer to see if it will pull it in. If not I am thinking that a spacer cut the same as the flang would work?

I compared them to what I had left from an original. It was rusted away from the elbow down. It lined up perfectly. The only thing I can see is that the original is a bit tighter on the curve and the flange is at 90deg to the pipe where they meet.

Has anyone else tried fitting theirs yet.

Kevin, don't take this as a hit to your work. What I got is very well made. They are a hard piece to copy due to the double bend in them.