|
|
#25
22-03-12, 02:15
|
||||
|
||||
Here are the pictures. I didn't get a chance to measure it but the distance they are out is about the same as the thickness of the flange. Im going to try some bolts that are a bit longer to see if it will pull it in. If not I am thinking that a spacer cut the same as the flang would work?
I compared them to what I had left from an original. It was rusted away from the elbow down. It lined up perfectly. The only thing I can see is that the original is a bit tighter on the curve and the flange is at 90deg to the pipe where they meet. Has anyone else tried fitting theirs yet. Kevin, don't take this as a hit to your work. What I got is very well made. They are a hard piece to copy due to the double bend in them.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
|
Threaded Mode