Thread: Vc 2047 lp2
View Single Post
  #54  
Old 26-04-15, 06:02
colin jones's Avatar
colin jones colin jones is offline
Registered User
 
Join Date: Jun 2007
Location: Adelaide
Posts: 1,810
Default

My gear change was 90 deg out so it is by far better to cut the pipe, bevel and reweld. Apart from being a quick repair, drilling new holes at 90 deg only leaves about 30% of material left. This way you are still using exactly the same holes. The front it almost complete apart from the clutch and accelerator rods and the cover.
Attached Thumbnails
IMG_3567.jpg   IMG_3568.jpg   IMG_3569.jpg   IMG_3574.jpg   IMG_3575.jpg  

Reply With Quote