Work on the fender is all completed. The cutting really allowed me to get a proper bend in place. I was also able to remove the excess stretched metal and keep it from puckering. I ended up using a tiny amount of JB-quick weld over the cured POR to fill a few minor pin holes from my welding. I sanded the JB weld down with a palm sander then over coated with POR again. This should seal it in forever.
__________________
Jordan Baker
RHLI Museum,
Otter LRC
C15A-Wire3, 1944
Willys MB, 1942
10cwt Canadian trailer
Last edited by Jordan Baker; 12-09-16 at 21:29.
|