![]() |
#33
|
||||
|
||||
![]()
Work on the fender is all completed. The cutting really allowed me to get a proper bend in place. I was also able to remove the excess stretched metal and keep it from puckering. I ended up using a tiny amount of JB-quick weld over the cured POR to fill a few minor pin holes from my welding. I sanded the JB weld down with a palm sander then over coated with POR again. This should seal it in forever.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer Last edited by Jordan Baker; 12-09-16 at 21:29. |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
1944 C-15A-Wire-5 Restoration | RichCam | The Restoration Forum | 706 | 18-05-23 02:43 |
Sold: 1944 Chev C15A Wire-3 | Don Dingwall | For Sale Or Wanted | 11 | 02-04-15 23:26 |
What was once 2, is now 1. (C15A-Wire-5) | RichCam | The Softskin Forum | 3 | 30-12-11 22:49 |
photos needed for c15a wire 3 van body | jason meade | The Softskin Forum | 5 | 10-08-11 06:29 |
Wire loom for C15A Cab13 | Jordan Baker | The Restoration Forum | 19 | 28-08-06 03:42 |