The power supply I'm using is the one (photo #4) that Bruce posted. It is a psu that supplies the necessary HT & LT to the set. It was made for the military, mine is dated from the 1950s.
The CPP2 only provides 12V or 24V to power the normal vibrator/dynamotor psu for the 19 set. You don't have to worry about the tubes/valves. The normal psu uses a 0Z4 rectifier.
The specs of the Rectifier#1 states that it works from 90V to 135V using inductors to regulate voltage but I'm not sure how well it works, as stated there are a lot of dead ones out there.
The photo shows the rectifier #1 in use here.
Last edited by Bruce MacMillan; 22-12-16 at 18:20.
|