![]() |
#10
|
|||
|
|||
![]()
The power supply I'm using is the one (photo #4) that Bruce posted. It is a psu that supplies the necessary HT & LT to the set. It was made for the military, mine is dated from the 1950s.
The CPP2 only provides 12V or 24V to power the normal vibrator/dynamotor psu for the 19 set. You don't have to worry about the tubes/valves. The normal psu uses a 0Z4 rectifier. The specs of the Rectifier#1 states that it works from 90V to 135V using inductors to regulate voltage but I'm not sure how well it works, as stated there are a lot of dead ones out there. The photo shows the rectifier #1 in use here. Last edited by Bruce MacMillan; 22-12-16 at 18:20. |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wireless of the Week - week 20 | Bruce Parker (RIP) | The Wireless Forum | 5 | 16-08-20 17:16 |
Wireless of the Week - week 5 | Bruce Parker (RIP) | The Wireless Forum | 20 | 26-12-19 22:39 |
Wireless of the Week - week 6 | Bruce Parker (RIP) | The Wireless Forum | 11 | 21-08-16 14:30 |
Wireless of the Week - week 7 | Bruce Parker (RIP) | The Wireless Forum | 3 | 16-07-16 23:47 |
Wireless of the Week - week 8 | Bruce Parker (RIP) | The Wireless Forum | 5 | 09-04-16 23:24 |