Free to good home

[George Moore]

Dont know if there is any interest, but I had a sort out in the workshop and found the following:

1/2" BSF Tap (16 TPI), I think its the starter tap, as the lower end would fit into the pilot hole.

1/2" BSW Die (12 TPI)
7/16" BSW Die (14 TPI)
7/16" BSF Die (18 TPI)
Barely used.

They were from stuff in my fathers garage, spanners sockets as follows:

BA sockets drivers, 2, 4, 6, 8 BA

Ring drivers, these are like a short socket but have a lug to one side so they can be hammered (not sure of the correct term)
Marked as follows:
1/4W
5/16W
3/8W
7/16W
All King Dick.

Sockets
Marked as follows:
5/8W
9/16 BSF - 1/2W
1/2 W
1/2 BSF - 7/16 W
5/16 BSF - 1/4 W
5/16 W
3/16 W


Ring spanners:
Marked as follows
1/2 W 5/8 W
1/2 W 9/16 W
3/8 W 7/16
1/2 BS+7/16 W - 9/16 BS+1/2 W
3/8 W - 7/16 W
3/8 W - 5/16 W
1/4 W - 5/16 W
3/16 - 3/16 W
5/16 - 3/8 W
5/16+1/4 W - 3/8+5/16W
1/4BS+3/16W - 5/16BS+1/4W
1/8W - 3/16W

OE spanners
1/2BS+7/16W - 9/16BS+1/2W (2)
1/2BS+7/16W - 7/16BS+3/8W
7/16BS+3/8W - 3/8BS+5/16W

Mostly King Dick, Britool, some Snap On sockets.

Good condition.

I would like a contribution towards postage be given to the MLU site.

Any takers ????

Job lot only

George.

george.dfs1@virginmedia.com
Phone: 01752227400