|
|
#2
27-11-19, 16:00
|
|||
|
|||
It looks the right general size and shape but I've seen so many "linkage by Bubba" that I won't guarantee what is the only "original, correct" setup.
Are you asking because the link may look a bit long for the spacing between the holes on the pedal arm and the cross-engine arm? If so, is there any adjustment in the vertical rod to the carburetor to allow the pedal in the place you need when at idle? 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gas pedal linkage hookup | Jordan Baker | The Carrier Forum | 8 | 22-05-14 22:36 |
| C15A pedal cut out | Svenn Ryen | The Softskin Forum | 0 | 10-02-13 10:20 |
| C15a gas pedal | Jordan Baker | The Softskin Forum | 3 | 27-02-12 17:23 |
| Clutch Pedal | gary_bath_jr | The Softskin Forum | 10 | 15-02-11 09:27 |
| Clutch pedal | Jordan Baker | The Carrier Forum | 0 | 12-04-06 03:21 |
Threaded Mode