|
|
#14
28-12-08, 23:13
|
||||
|
||||
Thanks...
...for all the suggestions and help. I measured 18mm but I think 3/4" would make sense. There is only a small lip in which to nest them which is why the originals are dished rather than cupped. It's interesting just the sump gasket managed to seal this in the past - but there was a lot of gunk built up in there.
Tony, have you tried the allen plugs? I would have thought they were too deep to fit.
__________________
Film maker 42 FGT No8 (Aust) remains 42 FGT No9 (Aust) 42 F15 Keith Webb Macleod, Victoria Australia Also Canadian Military Pattern Vehicles group on Facebook https://www.facebook.com/groups/canadianmilitarypattern 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode