![]() |
|
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
This is Excellent and just what I needed!
Do you think that a fairly competent welder, working alone, could build the majority of the box with the parts, before bolting the box together? And do you recommend that the parts be cut by laser cutter? There is a firm nearby that does good work at a reasonable price. Pedro |
#2
|
|||
|
|||
![]()
Ted
Your efforts deserve a prize in the CMP collecting community, for facilitating accurate reproduction. As to your price for the drawing package it is very modest in deed, if anyone has priced having blue prints copied will know, that's supposing you could get drawings to copy. About the question of who could reproduce the parts from the drawings. I would advise anyone going to a sheet metal shop go slow, before you sign on the line and/or place a deposit on the work be sure they have experience in work of this type. If you are contracting out the whole job for a completed assemble body, not a big issue as the shop if it is smart will check all the dimensioning before cutting and bending all the parts, because they are the ones who are going to have do all the trimming to align the body as they assemble it. If you are ordering the part and you plan to do the assembly it your self be careful, you are likely to get what ever piece of metal comes out of the metal brake first with little check to see if it matches the drawing. If you are going this route of having a sheet metal shop do all the cutting and bending while you do the assembly gives some real consideration to paying the shop for two hours of time to check the drawings accuracy and assembly logic. Then you have as set of drawings that shop says can be made and assembled, in this way they can not blame mistakes in fabrication on the drawings. I had some frame components produced from drawings for my C60L though the drawings were clearly marked and dimensioned "out side of bend to out side of bend" they were produced "inside of bend to inside of bend" result being that as the steel was 1/4 inch thick parts were all 1/2 inch to large.
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com |
#3
|
|||
|
|||
![]()
Has anyone heard from Ted? I've emailed him twice about these autocad drawings and haven't had a reply yet.
I was hoping to send him a private message but that option seems to be missing. Any help on this would be awesome as I'd really like to get the plans for this box. Pedro |
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Reference: 15-cwt GS body: 2H1 composite wood and steel | Hanno Spoelstra | The Restoration Forum | 5 | 10-03-19 19:08 |
Lindsay Steel Body Construction | mlombard | The Softskin Forum | 12 | 09-09-16 23:20 |
Reference: 30-cwt - 3 ton 3C1 GS Steel body (Q.M.G.) | Hanno Spoelstra | The Restoration Forum | 4 | 12-04-16 13:52 |
Steel Body Manufacturers | Steve Guthrie | The Softskin Forum | 3 | 14-07-10 17:18 |
Steel body and spare wheel carrier F15A | Manfred Müllner | The Restoration Forum | 1 | 17-11-04 11:27 |