New to MLU Forum

[Jacques Reed]

Hi Tony,
By all means you can use the photos.

I chalked the rivet hole areas yesterday and was able to find the ground flush rivets and pop them out. (See attached). That gives me a pretty good idea of the correct overall dimensions assuming the tabs are 1/2" wide as originally given to me, and the rivets are spaced down the centerline of the tabs as they appear to be in photos.
I have revisited the photos I recieved over a year ago and have tweaked a few measurments of the battery holder. The notch at the sides is 5-7/8" from the base when I zoomed in. (see attached).
My old draughtsman eye thinks maybe the sloping front of the sides is exactly 45 degrees. (a nice convenient line for the designer to draw with the 45-45 triangle) Would you be able to check it for me if you have a protractor or square? The measurements I was given comes in close but not exactly 45 degrees.
One other question. What is the thickness/gauge of the sheet metal? Looks pretty thin. The photos look like it is only about 2 mm (14 ga)
Brgds,

[Private_collector]

Jacques,

I'll let you know about those measurements on Thursday.
Tomorrow I won't be getting home until after 1800hrs & quite dark by then.

[Tony Wheeler]

Originally Posted by Private_collector

Jacques,

I'll let you know about those measurements on Thursday.
Tomorrow I won't be getting home until after 1800hrs & quite dark by then.

No need to poke around in the dark Tony, my F60S has a battery box which I can whip off and drop in to Jacques for a pattern. Like yours it needs replacing, so it can be flattened out to reproduce the blank more precisely, and even disassemble the riveted cover bolts for possible reproduction. Will be a lot easier than working off photos and measurements.

[Private_collector]

Too easy!

For what it's worth, the metal thickness of mine is:
Imperial 0.0595in or Metric 1.5mm
These measurements are on a section where there was minimal surface rust to increase thickness too much.

The angle Jacques was enquiring about is not 45 degree on my frame. It is just a little over 45.

Tony, I had already checked this afternoon, before I saw your email. Also your photo is exactly like mine, where as the photo Jacques posted on 14th, shows one with a shallow lip on the front. Which is correct???

Nothing is ever easy, is it!

[Tony Wheeler]

Originally Posted by Private_collector

your photo is exactly like mine, where as the photo Jacques posted on 14th, shows one with a shallow lip on the front. Which is correct???

Jacques' pic is correct - you and I have lost the front lip which is a separate piece. Looking closely at Keith's pic from the assembly instructions it appears to have a folded top edge, and the ends are folded around around the outside of the box, presumably spot welded to it.

Mine has been repaired in this area, with a new front lip being folded INSIDE the box, and roughly welded along the front edge. However you can see that the side has a cut away at the bottom to accommodate the thickness of the front lip, to make a neat flush join with the ends folded OUTSIDE. It's probably cleared on Jacques' pic which I've included here again.





The front edges of the box sides are recessed at the bottom to accommodate the thickness of the front lip section, making it flush with the whole front edge.

[Tony Wheeler]

Originally Posted by Tony Wheeler

it appears to have a folded top edge

Actually it may not, it could be just an artifact in the photo. All the straight lines appear to have been retouched.

[Tony Wheeler]

Here's a slightly higher res image. I'd say it's an artifact, not a rolled top edge. All the straight lines have this appearance from retouching.

[John Mackie]

Thank you all for the infiormation on fuel filters . I have checked it in my Fleetgaurd catologue and it all chechs out ok. I will buy some and be able to use these filters on my Jeep
Very usefull info.