need special 19 set dogbone

[Mike K]

Originally Posted by Bruce MacMillan

For Mike:

It sounds like you have a connector for use with the British HP amplifier. The 6 pin versions were #14 & #16 and the 12 pin version was #27. The 2 pin lead went to the socket marked "control" on the front of the amp.

Yes, that is the one Bruce . I have owned a few of the 19 set amps over the years, still have one here somewhere .

During the 1950's the Aust. army modified the 19 set amp., for use with the 122 set ( Aust) , the mod involved removing two of the 807's and fitting a meter in the front panel . A friend VK5WT had his 122 and the amp running , it put out around 50 watts carrier from memory . I did own one of those modified amps at one time .

[Peter Hommes]

I checked with a HP and power unit and they are indeed little different positioned than on a 19 set.

The odd one fits easily so it came with the lot of ws kit including a HP. I know now why it didn't fit a 19set + PU set up. Was just considering to make it fit.

see pictures; first one is inside with the extra wires connected in the centre and the second one with the ordinary bone.



top one in the second picture is the HP one



the odd thing is they have the same ordering number????

Connector
12 pt No 23A
(Canadian)
RCA 110076

Now the bad new I cannot sell it sorry

Peter Hommes
http://www.milmarket.org