Carrier Drivers Toolbox

[Euan McDonald]

Colin, you are a machine!
I would like to see a pic of an original canvas tool roll if anyone has one.

[Stew Robertson]

Colin I think you need a new hammer
I think some carpenter is missing a hammer

[colin jones]

Hi all, I have just about completed a few sets of bottom engine heat covers. I don't think many of these survived as they are really hard to find. These are a 2 piece cover with aspestos in the originals. I have used fibro cement and spot welded the pieces together. I will be selling these if anyone needs some.

[colin jones]

I have a very good original set to copy from.

[colin jones]

I had to make some serious press tooling to do these with quite thick steel not to mention a lot of them.
Colin.

[Scrivo18]

Hi Colin

I will have to check the ones that I have, but definitely would like to fill in a couple of holes where they are missing..

Will check tomoz and see which ones are required..

We refitted the engine on Thursday.. only drama is we have to much oil pressure...

Tim

[Paul Dutton]

Originally Posted by colin jones

I had to make some serious press tooling to do these with quite thick steel not to mention a lot of them.
Colin.

Colin, I've said it before and will say it again, excellent work friend!
No end to your talents!! Well done.

[colin jones]

I've just finished the last press tooling and done the put one together. Also made some small rivets to fit the inspection plate as per the original.