|
|
#9
21-08-13, 06:12
|
|||
|
|||
tyres
US NDCC tyres will go on WD rims but they are very hard to get off. You will most likely find you will need to get a truck tyre centre to remove them. I recently fitted 10.50 x 16 tyres to WD rims. Tyres were 'Specialty Tyres of America" brand. One went flat and I had to get a truck place to press the tyre off. Problem is the 5 degree angle on US tyres which has been well covered in other threads on this forum.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stuart VI Recce (was: Stuart Recce replacement) | Sparrow | The Armour Forum | 69 | 10-10-25 17:29 |
| CMP mirror replacement | Svenn Ryen | The Restoration Forum | 18 | 29-05-13 20:13 |
| Handbrake replacement | Little Jo | The Softskin Forum | 26 | 08-04-11 12:23 |
| Pin Replacement | LYLE CUNDALL | The Carrier Forum | 3 | 27-08-05 21:43 |
| Recommended Replacement? | Brad Mills | The Restoration Forum | 1 | 30-05-05 16:19 |
Threaded Mode