Fire Extinguisher Mounts

[super dave]

Interesting picture, I see the extinguisher mount sits high on the bracket in order to fit that location. I took a couple more picture of my mount showing it in both locations and that it fits the driver side division wall but not the gunners plate. Another observation I made of my mount is that it will only go one way and only the drivers position as it has two different hole sizes to mount it, top hole is 3/8 and the lower hole is 5/16 also the bent part has an 1/8 offset in the step at the top because of the angle to keep it level (see pics)

[super dave]

IS there no one out there that has a MK1 carrier with fire extinguishers mounted up front ??????? I have made a simple drawing of it and if someone could PLEASE see if they have an original bracket that they can get me the measurements to especially the gunner side:

A
B
C
D
E
F

Also I have seen a couple pictures with the reverse bend at the top and some at the bottom, Which end is up ??

[rob love]

Dave

I'll have a look at mine tomorrow after work. I may even have them at work....I'll check there too.

[super dave]

Thanks, Appreciate it

[Lynn Eades]

Dave, I have a CTL13276 bracket, which is the same both ends.
Let me know if you need info.

[rob love]

Here are some photos of two of the similar brackets. One has the extinguisher mount quite low, and one has it high. The screw holes in the back are different and match the brackets.

I have not taken these apart yet for sandblasting, but the high mounted one fits fine in the gunners position. Only problem is on the 2VP carrier I am working on, it is a mix of mk1 armour on a mk2 hull. I have to drill the hole through the angle iron yet for the bracket. Luckily it is through the armour (since the armour is mk1).

[super dave]

Originally Posted by rob love

Here are some photos of two of the similar brackets. One has the extinguisher mount quite low, and one has it high. The screw holes in the back are different and match the brackets.

I have not taken these apart yet for sandblasting, but the high mounted one fits fine in the gunners position. Only problem is on the 2VP carrier I am working on, it is a mix of mk1 armour on a mk2 hull. I have to drill the hole through the angle iron yet for the bracket. Luckily it is through the armour (since the armour is mk1).

Thanks for the pictures Rob, Interesting on the differences in the 6 mounting holes between the two Extinguishers and the mounting brackets.




So where does the mounting bracket come into place that I drew the picture of as I have seen pictures of them in other carriers, Later model ????

[super dave]

Originally Posted by Lynn Eades

Dave, I have a CTL13276 bracket, which is the same both ends.
Let me know if you need info.

Thanks for the offer Lynn, But I have that bracket as you see in the above pictures. It was the gunners bracket I was needing but was not sure what it looked like.