![]() |
|
|
|
#1
|
|||
|
|||
|
I recently used molasses to remove surface on the lift chain of an old air motor hoist I am refurbishing after reading another thread about it on here. After purchasing some at a local bulk grocery store (The Bulk Barn), I found it is also sold at our local feed supply house in gallon jugs for a lot less, and easier because you don't have to stand there for ages ladling it into the smaller container from the bulk pail. Slower than molasses in January....
I only left it in for a week, which was reflected by mediocre results, but I did this in an old windshield washer fluid gallon jug and find that it builds pressure after a couple of days at room temperature. I have it in my basement so it won't freeze and I don't doubt it could rupture the container if I didn't crack the lid open regularly to vent it. Something to be aware of when storing your left over mixture as it could make quite a mess. |
|
#2
|
||||
|
||||
|
Isn't one of the members doing a complete set of carrier tracks?
__________________
Charles Fitton Maryhill On., Canada too many carriers too many rovers not enough time. (and now a BSA...) (and now a Triumph TRW...) |
![]() |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Molasses Rust Removal | David Dunlop | The Restoration Forum | 38 | 22-04-16 03:02 |
| Rust removal, I gotta get this! | Harry Moon | The Restoration Forum | 4 | 15-03-16 03:00 |
| Rust Remover | Scott Hamilton | The Restoration Forum | 7 | 08-10-12 00:39 |
| Rust Resistant CMP | gjamo | For Sale Or Wanted | 0 | 17-12-05 08:34 |
| Rust pitting | jbledsoe | The Restoration Forum | 2 | 19-10-04 15:08 |