![]() |
|
#1
|
||||
|
||||
![]()
I suspect that the problem is I have the flanges below which are bolted in with a bolt and washer, in place of the flanges I need which are in Rob's manual drawing
s-l64.jpg DSC01316c.jpg I think the confusion has come from the flanges being removable, I suspect if I were to take them out the output end of the transmission would look exactly like the drawing in Rob's manual. And I think David is also correct, that picture I posted is the brakes, not the steering, pretty clear after reviewing Rob's steering diagram. So I think I am still on the hunt for the original two flanges that Rob identified early on...Thoughts? Last edited by jdmcm; 28-08-18 at 20:59. |
#2
|
|||
|
|||
![]()
As well as the flanges, I believe there will be seal retainers and seals.
I'll try and get outside for a photo of the loose powerpack. I believe Ian Newby has an operable M109 as part of his museum if you wanted to see one first hand. |
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
25 Pounder info needed. | Private_collector | The Gun Park | 392 | 10-03-24 21:00 |
Info needed from Canberra | Ron Pier | The Carrier Forum | 0 | 18-04-16 07:28 |
M109 SP gun | Bob Phillips | The Armour Forum | 12 | 06-02-16 00:45 |
FWD more info needed | bria0789 | The Softskin Forum | 9 | 14-07-07 09:17 |
fox info needed | Roger Condron | The Armour Forum | 31 | 19-10-05 22:33 |