Modern part numbers for CMPs

[Bob Carriere]

Hi Harry

Was at a seal wholesaler today and they still prefer to search by OD/ID since numbers vary from manufacturer and over time..... once found they give you a choice of made by 'who' where (time) and/ or shipping cost.

You can probably figure out the ID easy enough but it will be a hell of a tight fit to measure the OD without taking your T case out....

Any body on the forum that has a 2 speed already taken apart for measuring....
I would suspect that the size for the two rods on the 2 speed and the one speed T case are the same...... need some time to read and compare in the parts manual..........

Mine where tight when I rebuilt my t case...... one of the few parts I did not have to change.

Good luck