|
|
#10
28-11-19, 14:50
|
|||
|
|||
Simple jig
I have welded a piece of angle iron to a piece of square tubing
so I could clamp it in the vise on the drill press. Then make sure that when you pull the drill bit down as if you were drilling that it hits the bottom of the V in the angle. Then sit the round stock in the angle iron and it will not move and the hole will be centred when you drill. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gas pedal linkage hookup | Jordan Baker | The Carrier Forum | 8 | 22-05-14 22:36 |
| C15A pedal cut out | Svenn Ryen | The Softskin Forum | 0 | 10-02-13 10:20 |
| C15a gas pedal | Jordan Baker | The Softskin Forum | 3 | 27-02-12 17:23 |
| Clutch Pedal | gary_bath_jr | The Softskin Forum | 10 | 15-02-11 09:27 |
| Clutch pedal | Jordan Baker | The Carrier Forum | 0 | 12-04-06 03:21 |
Threaded Mode