|
|
#2
18-09-20, 05:46
|
|||
|
|||
I ended up making a steel bushing 0.880" OD x 0.630" ID that press-fitted into the 0.875" spring eye, and machining tapered ends on a 5/8" pin that matched the tapered holes in the shackle plates. I drilled from one end through to the centre of the pin and cross-drilled for grease injection, with the drilled hole tapped for a 1/4"-28 grease nipple.
Malcolm 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Front Axles for 10 bolt Front Hubs-1.5 ton Australian Chevrolet Trucks 1940-1945 | Philippe Jeanneau | The Softskin Forum | 30 | 28-01-22 11:19 |
| Front Brake Drums-10 bolt Front Hubs for 1.5 ton Australian Chevrolet Trucks, 40-45 | Philippe Jeanneau | The Softskin Forum | 1 | 10-04-19 21:51 |
| Info needed: Spring pins (suspension) | Jason Linders | The Restoration Forum | 2 | 27-08-18 16:22 |
| Wanted: Ford front suspension leaf (eye leaf) | Jason Linders | For Sale Or Wanted | 0 | 29-04-18 14:25 |
| Rear spring shackle pins | Jason Linders | The Restoration Forum | 4 | 08-09-15 00:53 |
Threaded Mode