Chev C60x rebuild

[Bob Carriere]

A pry bar????

Remove the sheet metal cover at the bottom of the bell housing..... it will reveal the ring gear......... with a long, long flat tip screwdriver try prying the flywheel using the teeth one way then the other....back and forth....... you may need to pour more diesel even into the carb intake ...... literally flood it.... let it sit and try the pry bar again and again back and forth......

If it does not work.....quit....no point being fanatical about it...... it will need to be taken apart........

Good luck....

PS....... may be silly but make sure the tranny is in neutral and that the
CLUTCH DISENGAGED....AND IS NOT RUSTED TO THE FLYWHEEL.......