|
|
#9
09-11-25, 01:34
|
||||
|
||||
Bolt
Hi Larry
Bit of a long shot... Maybe you could ask around and find someone close by who does hobby machining. Have a look at the Canadian metalwork forums. https://canadianhobbymetalworkers.com/ That bolt could be made on a lathe. I can do it but I'm on the other side of the planet. Get a ruler or better, callipers and count the number of threads over 1/4 inch, multiply that number by 4 and that gives you the threads per inch (TPI) These guys are in Saskatchewan https://canadianhobbymetalworkers.co...atchewan.2713/
__________________
1940 cab 11 C8 1940 Morris-Commercial PU 1941 Morris-Commercial CS8 1940 Chev. 15cwt GS Van ( Aust.) 1942-45 Jeep salad Last edited by Mike K; 09-11-25 at 01:56. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wanted: Oil filter fitting | Francois Buloup | For Sale Or Wanted | 4 | 30-01-20 10:34 |
| For Sale: No12 cab roof hatch fitting | rnixartillery | For Sale Or Wanted | 0 | 02-01-20 14:59 |
| Front wheel cylinder fitting | M38CDNBill | Parts/Sources/Prices | 6 | 08-11-17 16:51 |
| Fitting tall guys in Cab 11/12's | svdwal | The Softskin Forum | 35 | 22-03-16 02:27 |
| LP2A fitting question | Lynn Eades | The Carrier Forum | 15 | 08-10-11 21:47 |
Threaded Mode