|
|
#30
15-07-08, 00:23
|
||||
|
||||
i have done it 2 ways....
1 scor the nuts and chisel the nut in half without damaging the threads on the bolt. then replace the bolt. you can make a cage bolt with a pice of stock and a grinder. 2 cut the darn thing off with a angle grinder and make a new bolt with the base of the old one. i would not even think of useing the old nuts again. also if you have a MK I carrier just remember that some parts out there from MK II will NOT fit on your carrier. keep that in mind when you are out there buying parts. removing the bolts is going to be the fun part. dave
__________________
44 GPW, 43 MB, 42 trailer, 43 cckw 44 MORRIS C8, M-3A1 SCOUT CAR 41 U/C, 42 U/C x 2, 44 U/C 42 6LB GUN and the list keeps growing, and growing.... i need help LOL 
|
|
|
Threaded Mode