|
|
#1
17-07-08, 05:54
|
||||
|
||||
Loading vehicle onto flatbed truck
Hi everyone
I may be taking my Carrier to an event in a few weeks but i need to figure what the best way is to load and unload from the truck. I would be using a 24' flatbed with the deck being 4.5 feet off of the ground. Sadly it does not tilt. If I had to go with ramps what would be the best way to figure out the length needed. Ive also thought about trying to back the truck up to some higher ground to aid in the loading. Any thoughts would be most appreciated as I don't want to injure myself or the carrier.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
#2
17-07-08, 06:01
|
||||
|
||||
|
When I took my Cletrac to the Saskatoon airshow I backed uo to their loading docks for semis and drove it off into the building then went out the other doors at ground level. Loading it in my yard I back up in the ditch to the shoulder of the road then use about 5 foot long ramps and drive it on. You have a lot of leeway when you have tracks.
__________________
1940 Cab 11 C8 Wireless with 1A2 box & 11 set 1940 Cab 11 C8 cab and chassis 1940 Cab 11 C15 with 2A1 & Motley mount & Lewis gun 1940 Cab 11 F15A w/ Chev rear ends 1941 Cab 12 F15A 1942-44 Cab 13 F15A x 5 1942 cab 13 F15A with 2B1 box 1943 cab 13 F15A with 2H1 box 1943 Cab 13 C8A HUP 1944 Cab 13 C15A with 2C1 box 1943 Cletrac M2 High Speed Tractor MkII Bren gun carrier chassis x 2
|
 |
|
|
Linear Mode
