|
|
|
|
#1
14-04-09, 00:18
|
||||
|
||||
I think its the same as the rest of the carrier. Should be 1/4" thick and 1 1/4" x 1 1/4"
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
#2
24-06-09, 10:00
|
||||
|
||||
|
battery box
Hi, A couple of questions on Jordans info on the armoured battery box, The side plate rivets, 3/4" to the rivet centre or side of the rivet?. the internal angle iron 1 1/4" by 3/16" thick?. What are the measurements for the internal piece of angle iron with the cutouts in?. The side rivets are they 5/16" hammered flat on the inside?. finally the back plate screw holes, seem to have a threaded part welded on the angle iron, was this just on the back plate and not on the front angle iron for attaching to the carrier?.
oh,,,,,,also location holes for mag cherger box also, distance from rear please. has any one got a couple of lid catches, just the bit attached to the lid laying around for trade please. thanks kevin. 
__________________
2pdr Tank Hunter Universal Carrier 1942 registered 11/11/2008. 3" Mortar Universal Carrier 1943 registered 06/06/2009. 1941 Standard Mk1 stowage Carrier, Caunter camo. 1941 Standard Mk1 stowage Carrier, light stone. 10 cwt wartime mortar trailer. 1943 Mk2 Daimler Dingo. 1943 Willys MB. 1936 Vickers MG carrier No1 Mk1 CMM 985.
|
 |
|
|
Hybrid Mode
